Separate names with a comma.
How sure are you its supplied by Norton?
I thought it was ali/gator, Internet seems to back it up...
Actually I have measured lumber for length width thickness and weight
but guess what,
the lumber advertising explained what to expect,
common law, items sold should be as-advertised
spyderco doesn't advertise 8in x 2in nominal,
or warn size may vary by 1/16inch,
Guided freehand, seriously :)
Its just a bit of tape/cardboard for easier visualization
Why should sharpening require more precision than...
Basically too much trust/confidence in a very strict tolerances machine (tester) that turned out to be incorrectly assembled. Problem was...
So, many years of cutting coconuts has fatigued the edge? It now needs a 1mm removed from edge before stabilizing?
If 25 degrees per side works for you , stick with it
If 20 dps works better for you, go for it
Will using the P80 GREEN belt save you time...
says diamonds not required
this guy even used CrO with success
If you have a sheet of sandpaper ,
turn your mockup into a sharpener
It doesn't take much, pencil , popsicle stick, binder clip..
don't sit on it, that stool analogy is falling apart/out
A better analogy is chocolate chip cookies / bread
Too much chocolate...
I dont know,
Seems like a mystery,
.060in = 1.524 mm
.125in = 3.175 mm
and " tsprof.com constructor " says
K02 Single Clamp 5mm minimum...
Two ideas, carbide volume and sharpening procedure
0) high carbide volume is high
No its not what you get by skipping grits.
Its just the pictures from earlier ,
one on top of another to show the difference in "serrations"....
Big teeth are strong :) yet easy to remove.
Its more about the height than thinness
"wasting steel" or some such
It can take a dozen...
Yes, blade shaves on only one side, burr is still there.
The four strokes is more about not re-creating a burr after removing the burr first
Why not buy straight diamond powder ?
It might in some cases,
The idea behind it is it should smash/fold over any burr,
which should then be easier to detect,
for example by...
SR101 is low alloy , this means easy to grind
Paint it green!
Grind a relief until you only have 1mm width of green remaning on the front...
How will you notice if they get sharper?
Push cut through cigarette papers?
Hanging Hair Test?
Cut thread on a scale?
How are you measuring sharpness?
What are your last 20 strokes on the KME exactly (how are you removing burr)?
What do you mean by "just...