First PM2. Question on blade drop

Discussion in 'Spyderco' started by AML1, Apr 27, 2020.

  1. Bigfattyt

    Bigfattyt Gold Member Gold Member

    Jun 23, 2007
    I leave a pivot alone for the most part. Break in, and then see.
     
  2. AML1

    AML1

    13
    Apr 27, 2020
    looking online I can’t seem to find a T6 in Torxplus. They seem to use a different size. Or am I just looking in the wrong place?
     
  3. AML1

    AML1

    13
    Apr 27, 2020
    I plan on leaving the pivots alone for now, but it is tempting just to back them off a bit :)
     
  4. Ajack60

    Ajack60 Platinum Member Platinum Member

    Apr 21, 2013

    Go look on the big river site, they sell a variety of Wiha bits

    C72E3C53-C740-4C43-8165-8F5823A369FD.jpeg
     
  5. AML1

    AML1

    13
    Apr 27, 2020
    thanks for the info. So using the picture you attached is “IP6” roughly the same as “T6”?
     
  6. Ajack60

    Ajack60 Platinum Member Platinum Member

    Apr 21, 2013
    Yes
     
    AML1 likes this.
  7. Richard Coyle

    Richard Coyle Gold Member Gold Member

    173
    Nov 12, 2019
    I don’t see anything wrong with trying to loosen the pivot a little, I’ve gotten a Spyderco that was a little tight from the factory.
    If it’s a big enough deal for you to start a thread about, why not try it?

    Worst thing that can happen is you might need to put a little locktite on it, probably not though.


    Why wait when you can know now???!! lol
     
  8. AML1

    AML1

    13
    Apr 27, 2020
    I wouldn’t call it a big deal. Rather a good excuse to make my first post :)

    and really just wanted to know how most PM2’s are out of the box. At least now I know.
     
    Richard Coyle likes this.

Share This Page